[340] TIE Line Routing Table
Description
The TIE line routing table can be programmed. This table is referenced by the system to
identify the outside line route, when an extension user makes a TIE call.
A routing pattern appropriate for each call is decided by the first three digits (except the TIE
line access number) of the dialled number. This programme assigns the TIE line access number
and outside line group hunt sequence.
Selection
• Location number: 01 through 32
• TIE line access number: 1 through 3 digits
• Outside line group hunt sequence number: 1 through 8 (5 entries max.)
Default
All locations – Not stored
Programming
1.
Enter 340.
Display: 340 TIE ROUTE
2.
Press NEXT.
Display: Location NO?
3.
Enter a location number.
To enter location number 01, you can also press NEXT.
Display example: 01:
4.
Enter a TIE line access number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new number.
5.
Press
6.
Enter an outside line group hunt sequence number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new number.
7.
Press STORE.
8.
To programme another location, press NEXT or PREV, or SELECT and the desired
location number.
9.
Repeat steps 4 through 8.
10.
Press END.
General Programming
to programme the outside line group hunt sequence number.
2.4 TRS / ARS Programming
165