Flash Time - Panasonic KX-TD816 Programming Manual

2.5 Outside Line Programming

[413] Flash Time

Description
Assigns the length of the flash time. If your system is installed behind a host PBX, External
Feature Access (EFA) is necessary to obtain their services. To enable it, select a required
hooking signal sending time for the outside line group.
Selection
• Outside line group (TRG) number: 1 through 8,
• Time (milliseconds):
Disable (no EFA) / 80 / 96 / 112 / 200 / 300 / 400 / 500 / 600 / 700 / 800 / 900 / 1000 / 1100
/ 1200
Default
All outside line groups – 600 ms
Programming
1.
Enter 413.
Display: 413 FLASH TIME
2.
Press NEXT.
Display: TRK GRP NO?
3.
Enter an outside line group number.
To enter outside line group number 1, you can also press NEXT.
Display example: TRG1: 600 msec
4.
Keep pressing SELECT until the desired time is displayed.
5.
Press STORE.
6.
To programme another outside line group, press NEXT or PREV, or SELECT and the
desired outside line group number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• You may disable EFA, if not required. The Flash feature will be in effect in place of EFA.
Programme [414] Disconnect Time is used to select the time required for the Flash
feature.
• The flash time required is determined by the central office or the host PBX lines.
• To assign all outside line groups to one selection, press the
display shows the contents programmed for outside line group 1.
190
( =all outside line groups)
key in step 3. In this case, the
General Programming