Table of Contents
Advertisement
4.6.0 MAl NTENANCE (285 Ipm)
4.6.1 Printer Cover and Divider
Removal and Replacement
Removal
1.
Remove the left and right knobs
lEt
by
pulling them from the shaft.
2.
Open the printer cover.
3.
Pull forward on the left and right sliding
latches
III
and remove the printer cover.
4.
Remove the three screws
Ii
under the
keyboard, slide the cover forward slightly
to disengage tabs, and remove the keyboard
cover.
5.
Remove the two divider screws
II
and
remove the divider.
6.
The back cover
II
is held on by two ears
on the cover; therefore, it can be lifted off.
Replacement
1.
Replace in the reverse order of removal.
2.
Do the Cover Interlock Switch service check.
(4.6.2.1).
4.6.1.1 Printer Cover Grounding
II
Cable
ED
Cable
m
Jumper
II
Jumper (connect to frame of printer behind
right tractor)
13
Jumper
. .
Jumper
Ground forms stand at grounding blocks.
Belt Printer
285 Ipm
4-97
Advertisement
Table of Contents
