Chapter 2. Removal, Replacement, And Installation Procedures - IBM IntelliStation POWER 9114 Model 275 Manual To The Installation

Chapter 2. Removal, Replacement, and Installation
Procedures
This chapter provides removal, replacement, and installation procedures for the Model 275.
Notes:
1. Servicing of the Model 275 can be performed with the system either in the vertical or horizontal
position.
2. Before performing any of the removal or replacement procedures in this chapter, read the following
danger and caution notices.
3. If your system has a failure for one of the listed devices, refer to Appendix D, "Component and
Attention LEDs", on page 71. When you have determined which device is the source of the problem,
return to these procedures.
4. Only optional parts that are available for your system have installation procedures.
5. In the system, the ac power interface connector is considered the main power disconnect device.
6. This system has redundant power supply capabilities, meaning that it has the ability to have two power
supplies running simultaneously in the same system unit. When instructed to disconnect the power
source, ensure that all power cables have been unplugged.
DANGER
An electrical outlet that is not correctly wired could place hazardous voltage on metal parts of
the system or the devices that attach to the system. It is the responsibility of the customer to
ensure that the outlet is correctly wired and grounded to prevent an electrical shock.
Before installing or removing signal cables, ensure that the power cables for the system unit
and all attached devices are unplugged.
When adding or removing any additional devices to or from the system, ensure that the power
cables for those devices are unplugged before the signal cables are connected. If possible,
disconnect all power cables from the existing system before you add a device.
Use one hand, when possible, to connect or disconnect signal cables to prevent a possible
shock from touching two surfaces with different electrical potentials.
During an electrical storm, do not connect cables for display stations, printers, telephones, or
station protectors for communications lines.
D05
3