Table of Contents
Advertisement
3.2.6 Latch Assembly
Removal and Replacement
1.
2.
3.
4.
5.
Unlatch the 33FD and slide it forward
on the base.
Loosen the top cover mounting screws
rl
and remove the cover.
Remove the two latch mounting screws
Ii·
Pull latch
m
out toward front of cover.
To replace, reverse the above procedure.
3.2.7 Collet
Removal and Replacement
1.
2.
3.
4.
5.
6.
7.
Turn power off at the operator control
panel.
Remove the 33FD from the machine
(3.2.5).
Remove the covers (3.2.8).
Remove mounting screw and washer
m.
Remove collet assembly
IJ
,spring, and
washer
m .
Remove collet
Ii
To replace, reverse above procedure.
CAUTION
Before replacing
cover screws, posi-
tion actuator bail
under pressure pad
arm.
11---...,;
3-12
3.2.8 Cover Assembly
Removal and Replacement
CAUTION
Do not allow pressure pad arm to snap against
the head.
1.
2.
3.
Turn power off at the operator control
panel.
Remove the 33FD from the machine
(3.2.5).
Loosen top cover mounting screws
rJ
and remove top cover.
4.
Remove two screws while holding side
cover.
5.
6.
7.
Remove cover carefully to avoid damage
to wires.
Remove wires from LED and actuator.
(Yellow wire goes to LED terminal marked
y.)
Remove wires from the clip on the cover.
CAUTION
Before replacing cover
screw~,
position
actuator bail under pressure pad arm.
8.
Adjust the nudger
m
so that it lightly
contacts the diskette when the diskette is
fully inserted and the cover is closed.
9.
To replace, reverse the above procedure.
Advertisement
Table of Contents
