IBM System/32 Introduction And Maintenance Manual page 350

9-42
9.2.36 Print Head Cable
Removal
1.
Turn power off at the operator control panel
5. CAUTION
7.
Work the cable out of the slots in the casting
and remove the printer covers.
When loosening the print emitter pickup
III
and push the connector through the
mounting screws, the coil spring
III
might
hole.
2.
Remove the print head (9.2.34). Adjust the
fly out.
print head on installation.
8.
Remove two screws from the cable clamp
Loosen the print emitter pickup cable clamp
assembly
II
(long flat spring with plastic
3.
Separate the printer from the power supply
g
. Remove the clamp screw on the left
on ends) and remove the old cable.
(9.2.2). Observe the cable routing to aid in
side and remove the wires from under the
replacing the cable.
clamp.
4.
Remove P2A and P2B
r.i3 .
Note how P2B
6.
Loosen the belt clamp
m .
Remove the
is plugged.
cable clamp bracket
m
(two screws).
m~------------------