Table of Contents
Advertisement
9.2.2 Separating The Printer From The
Power Supply
1.
Turn power off at the operator control
panel.
2.
Remove the printer cover (9.2.1).
3.
Remove the cable clamp
B
near EC1.
4.
Unplug EC1
m
and EC2
II.
For installa·
tion, be sure the print head cable is against
the flat spring.
5.
Remove two screws on the right end of the
printer
a
(when CE is facing the printer).
6.
Loosen two screws
m
on the left end of
the printer.
7.
Lift the right end of the printer sl ightly and
slide the printer to the right to clear the
screws
iii. .
8.
Lift the printer from the power supply. If
the underside of the printer is to be serviced,
remove the paper deflector and set the
printer into the service position
II
on the
base (so that the print emitter points up·
ward). Secure the printer in this position
with a base screw
m
on the left side and a
base screw
rJ
on the right side.
Note:
Open the ribbon feed rolls and make
sure the ribbon box cover remains closed.
9.
To reassemble the printer on the power
supply, reverse this procedure.
9-14
i
I
I
m
Cable - - - - - '
Clamp
(DEC1-----------------
DEC2-----------------------,
Advertisement
Table of Contents
