Table of Contents
Advertisement
Replacement
1.
2.
3.
4.
Install the replacement shock mount on
the subframe using the top screw
m .
Make sure that the shock mount has the
correct part number (the disk drive uses two
types of shock mounts).
Make sure the shock mount is upright and
install the screws, nuts, and washers
m
to hold the mount to the machine frame.
Loosen the two screws
13
that hold the
spindle locking arm, and slide the locking
arm away from the disk spindle.
Make sure the spindle antistatic brush is
contacting the center of the spindle.
Note:
If there is a wear crater on the spin-
dle antistatic brush, realign the crater to
the spindle.
5.
Tighten the two screws that hold the
locking arm.
6.
Check that the spindle antistatic brush
has a pressure of
60
+
25 - 20
grams on
the center of the spindle. Adjust, if nec-
essary, by removing and forming the
brush.
7.
Install the belt guard
II .
Slide the belt
guard all the way to the left and tighten
the screws.
8.
Unlock the actuator by moving the handle
B
to OFF.
~~::-----m
Disk Drive
2-25
Advertisement
Table of Contents
