Print Units With Pivot Screws And Two - IBM System/32 Introduction And Maintenance Manual

· 4.2.45 50, 100, and 155 Ipm Forms
Tension Assembly (Continued)
4.2.45.1 Print Units with Pivot Screws
and Two Paper Clamp Engaging
Levers (Continued)
Replacement
1. Install the assembly in reverse order of
removal.
2. Perform the service check steps 5, 6, and 7.
3. Install the print unit assembly.
4. Place the printer in the operating position
and install the rear forms guide and covers.
5. Install the two printer mounting screws
under the frame.
m
Measure at this point with power off
Folded Paper
Guide to Form
the Tension Springs
Forms Tension Spring
Belt Printer 50, 100, and 155 Ipm 4-65