Table of Contents
Advertisement
33FD Diskette Drive
o
1. Observe that card and all cables and
connectors
0
are in place.
o
2. Rotate drive pulley
OJ
manually to check
for free rotation.
o
3. If the protective shield was removed
during unpacking, reinstall it.
Front View
m-----OJ"""""'"
Belt Printer
CAUTION
Wire paper guide
m
on bustle
13
must be below
wire paper guide on printer before sliding bustle
into position.
o
1. Install bustle
13
which mounts by sliding
into place on the three studs
III
on rear of
printer and install knobs
iii.
Install ground
wireD·
o
2. Install bustle cover
D
with 4 screws.
Adjust cover to match contour of the
bustle. Install ground wire at
m
and
II.
o
3. Install forms guide
m
and set right-hand
movable guide to
O.
o
4. Install ribbon by follqwing the diagram on
the i'1side of printer cover.
o
5. Do the Cover Interlock Switch service check
(4.2.2.1)
Note: Be sure the ribbon does not jam
between the ribbon drive roll and the ribbon
cassette. For more details, see IBM System/32
Operator's Guide, GC21-7591.
$erial Printer
o
1. Install
t~e
forms tractor assembly
II
com-
plete with wire paper guide, on printer.
o
2. Slide the two plastic paper guides
m
onto the
paper entry plate.
Installation Instructions
C-3
Advertisement
Table of Contents
