Table of Contents
Advertisement
9.2.0 MAINTENANCE
9.2.1 Printer Cover
Adjustment
1.
Center the platen knobs vertically and main-
tain a gap of 1/8 inch to 5/32 inch (3.18
mm to
3.96
mm) between the top cover and
the forms tractor by adjusting the pads in
back
m
and the double nuts in front
m.
2.
Position the printer horizontally on the
double nut studs ~ to center the paper
release lever and forms mode selector lever.
Removal
1.
Turn power off at the operator control
panel.
2.
Remove the forms tractor unit (9.2.7).
3.
Remove the platen
(9.2.3).
4.
Pull off the horizontal fine adjustment
knob
[t.
5.
Loosen the fasteners
tl
and remove the
covers.
6.
To replace, reverse this procedure.
~~~-+
__
------~.m
Serial Printer
9-13
Advertisement
Table of Contents
