Daewoo MATIZ Service Manual page 898

DAEWOO M-150 BL2
SUPPLEMENTAL INFLATABLE RESTRAINTS (SIR) 8B – 71
5. Properly align the pointed marks (
6. Connect the electrical connectors on the lower
7. Install the lower/upper steering column cover.
8. Install the steering wheel. Refer to Section 6E,
9. Connect the driver airbag module and the horn con-
10. Install the driver airbag module. Refer to "Driver air-
11. Connect the negative battery cable.
PASSENGER AIRBAG MODULE
(Left–Hand Drive Shown, Right–Hand
Drive Similar)
Tool Required
DS 401 Torx Bolt Wrench.
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the glove box. Refer to Section 9E, Instru-
ment/Driver Information.
3. Disconnect the passenger airbag module connector.
D110B508
4. Remove the passenger airbag module.
D Remove the nuts (1).
D Remove the airbag module torx bolts using a torx
D Remove the passenger airbag module (2).
D110B509
Installation Procedure
1. Install the passenger airbag module.
2. Install the passenger airbag module mounting torx
10 NSm
bolts and the nuts using a torx bolt wrench DS 401.
Tighten
D Tighten the passenger airbag module torx bolts to
15 NSm
D Tighten the passenger airbag module nuts to 10
Notice : Do not reuse the removed torx bolts.
Replace the torx bolts with the new ones.
D1AB510A
ponents of the clock spring.
spring steering column.
Steering Wheel and Column.
nectors.
bag module" in this section.
bolt wrench DS 401.
a. Passenger airbag module torx bolt.
15 NSm (11 lb-ft).
a. Passenger airbag module torx bolt.
NSm (89 lb-in).
b. Passenger airbag module nut.
) on the com-