Installation; Wheel Opening Molding; Removal - Dodge Dakota Sport 2001 Service Manual

AN
SIDE VIEW MIRROR (Continued)
(6) Separate side view mirror from vehicle.
Fig. 12 Mirror Flag Door Seal
1 - STUFFERS
2 - MIRROR FLAG SEAL

INSTALLATION

(1) Position side view mirror on vehicle.
(2) Install harness grommet in door frame, if
equipped.
(3) Install nuts attaching side view mirror to door
frame. Tighten nuts to 7 N·m (65 in. lbs.) torque.
(4) Engage power mirror wire connector from door
harness, if equipped.
(5) Install mirror flag seal.
(6) Install door trim panel.
Fig. 13 Side View Mirror Connectors
1 - ELECTRIC FOLD AWAY SIDEVIEW MIRROR
2 - DOOR
3 - ELECTRIC SIDEVIEW MIRROR

WHEEL OPENING MOLDING

REMOVAL

(1) Remove the screws attaching the wheel open-
ing molding to the fender (Fig. 1).
(2) Separate the molding from the wheel opening.
INSTALLATION
(1) Clean body surface with MOPAR Super Kleen
solvent or equivalent. Wipe surface dry with lint free
cloth.
(2) Position the molding in the wheel opening.
(3) Remove the backing and press to secure mold-
ing.
(4) Install the screws attaching the wheel opening
molding to the fender.
EXTERIOR 23 - 85