23 - 76
DOORS - REAR
REAR DOOR WATERDAM (Continued)
Fig. 12 Rear Door Waterdam
1 - WATER DAM
2 - REAR DOOR
INSTALLATION
(1) Route the latch rods and wire harnesses
through the waterdam.
(2) Position the waterdam on the door, apply adhe-
sive as necessary and press into place.
(3) Install door trim panel.
REAR DOOR WINDOW
REGULATOR
REMOVAL
(1) Remove the door inner trim panel.
(2) Remove the door waterdam and speaker, if
equipped.
(3) Remove the inner and outer beltline weather-
strip.
(4) Lower the door glass.
(5) Remove the bolts attaching the regulator to the
glass.
(6) Raise the glass manually and secure in the
door frame.
(7) Loosen the regulator attachment nuts and
remove the regulator attachment bolts.
(8) Disengage regulator wire harness.
(9) Remove the regulator (Fig. 13).
Fig. 13 Rear Door Window Regulator
1 - HARNESS CONNECTOR
2 - POWER WINDOW REGULATOR
INSTALLATION
(1) Position the window regulator in the door.
(2) Install the fasteners attaching the regulator to
the inner door panel.
(3) Engage the regulator wire harness.
(4) Lower the glass manually and install the bolts
attaching the regulator to the glass.
(5) Cycle the glass to ensure correct operation.
(6) Install the inner and outer beltline weather-
strip.
(7) Install the door waterdam and radio speaker, if
equipped.
(8) Install the door trim panel.
AN