Installation; Rear Wheelhouse Splash Shield; Removal; Right Front Fender - Dodge Dakota Sport 2001 Service Manual

AN
LEFT FRONT FENDER (Continued)
Fig. 9 Front Fender
1 - FRONT FENDER
2 - BRACKET
3 - U-NUT
4 - DASH PANEL
5 - U-NUT
(9) Install HCU if equipped. (Refer to 5 - BRAKES/
HYDRAULIC/MECHANICAL/HCU
CONTROL UNIT) - INSTALLATION)
(10) Install battery support bracket and battery
tray.
(11) Install PDC (power distribution center).
(12) Install left headlamp module.
(13) Install battery.
(14) Install wheelhouse liner.
(15) Install wheel opening molding.
(16) Install left front wheel.
(17) Remove the support and lower the vehicle.
REAR WHEELHOUSE SPLASH
SHIELD

REMOVAL

(1) Remove bottom screw attaching wheel opening
molding to cargo box.
(2) Remove screws attaching splash shield to inner
wheel house (Fig. 10).
(3) Separate splash shield from vehicle.

INSTALLATION

(1) Position splash shield in wheel house.
(2) Install screws attaching splash shield to inner
wheel house.
(3) Install bottom screw attaching wheel opening
molding to cargo box.
1 - U-NUT
2 - REAR SPLASH SHIELD
3 - FRONT SPLASH SHIELD
4 - U-NUT
5 - CARGO BOX
6 - U-NUT
7 - U-NUT
(HYDRAULIC

RIGHT FRONT FENDER

REMOVAL
(1) Disconnect battery negative cable.
(2) Raise and support the vehicle.
(3) Remove right front wheel.
(4) Remove wheel opening molding.
(5) Remove wheelhouse liner.
(6) Remove right headlamp module.
(7) Remove air cleaner element housing.
(8) Remove powertrain control module.
(9) Disengage clips attaching wire harnesses to
inner fender and wheelhouse.
(10) Remove bolt attaching fender to lower rocker
panel.
(11) Remove bolts attaching fender to lower radia-
tor closure panel (Fig. 11).
(12) Remove bolts attaching fender to hood hinge
support bracket.
(13) Remove bolts attaching fender to upper cowl.
(14) Remove bolts attaching fender to upper radia-
tor closure panel.
(15) Separate fender and wheelhouse from vehicle.
INSTALLATION
(1) Position fender and wheelhouse from vehicle.
(2) Install bolts attaching fender to upper radiator
closure panel.
(3) Install bolts attaching fender to upper cowl.
EXTERIOR
Fig. 10 Rear Splash Shield
23 - 83