Instructions For The 3M Connector - Mitsubishi melservo-j2 series Instruction Manual

3. SIGNALS AND WIRING
2) Connection
Insert the core of the cable into the opening and tighten the screw with a flat-blade screwdriver so
that the cable does not come off. (Tightening torque: 0.5 to 0.6N•m) Before inserting the cable into
the opening, make sure that the screw of the terminal is fully loose.
When using a cable of 1.5mm

3.12 Instructions for the 3M Connector

When fabricating an encoder cable or the like, securely connect the shielded external conductor of the
cable to the ground plate as shown in this section and fix it to the connector shell.
External conductor
Strip the sheath.
2
or less, two cables may be inserted into one opening.
To loosen. To tighten.
Sheath
Screw
Cable
Screw
Ground plate
Flat-blade screwdriver
Tip thickness 0.4 to 0.6mm
Overall width 2.5 to 3.5mm
Cable
Opening
Control circuit terminal block
Core
External conductor
Pull back the external conductor to cover the sheath
3 - 34
Sheath