Positioning Operation; Multidrop System - Mitsubishi melservo-j2 series Instruction Manual

4. OPERATION

4.6.2 Positioning operation

Positioning operation can be performed by changing the point table settings and making a start. For
example, positioning operation can be performed by writing the data of point table No.1, then specifying
point table No.1, and making a start.
For transmission data details, refer to Chapter 8.
Transmission data
Servo motor speed
No.
1) Point table No.1 position data write
2) Point table No.1 speed
3) Point table No.1 acceleration time constant
4) Point table No.1 deceleration time constant
5) Point table No.1 auxiliary function
6) Point table No.1 selection
7) Forward rotation start (ST1) ON
8) Forward rotation start (ST1) OFF

4.6.3 Multidrop system

The RS-422 communication function can be used to operate several servo amplifiers on the same bus. In
this case, set the station numbers to the servo amplifiers to determine the destination servo amplifier of
the currently transmitted data. Use parameter No.15 to set the station numbers.
Always set one station number to one servo amplifier. Normal communication cannot be made if one
station number is set to two or more servo amplifiers. When using one command to operate several servo
amplifiers, use the group designation function described in Section 4.6.4.
Controller
1) 3)
2) 4)
Values set with transmission data 1) to 5) are used for operation.
Transmission Data
MITSUBISHI MITSUBISHI
To CN3
CHARGE CHARGE
Axis 1 Axis 2
(Station 0) (Station 1)
For cable connection diagram,
refer to Section 8.1.1.
8)
5) 6) 7)
5ms
Command
[C] [0]
[C] [6]
[C] [7]
[C] [8]
[C] [B]
[9] [2]
[9] [2]
[9] [2]
MITSUBISHI
To CN3 To CN3
CHARGE
Axis 3
(Station 2)
RS-422
4 - 33
Data No.
[0] [1]
[0] [1]
[0] [1]
[0] [1]
[0] [1]
[6] [0]
[6] [0]
[6] [0]
MITSUBISHI
To CN3
CHARGE
Axis 32
(Station 31)