Display And Operation; Display Flowchart - Mitsubishi melservo-j2 series Instruction Manual

7. DISPLAY AND OPERATION

7. DISPLAY AND OPERATION

7.1 Display Flowchart

Use the display (4-digit, 7-segment LED) on the front panel of the servo amplifier for status display,
parameter setting, etc. Set the parameters before operation, diagnose an alarm, confirm external
sequences, and/or confirm the operation status. Press the "MODE" "UP" or "DOWN" button once to move
to the next screen.
To refer to or set the expansion parameters, make them valid with parameter No.19 (parameter write
disable).
Status display
Motor speed Sequence
[r/min]
Regenerative load Software version
ratio [%] L
Effective load ratio Software version
[%] H
Peak load ratio
[%]
Within one-revolution
position [pulse]
ABS counter
[rev]
Load inertia
moment ratio
[times]
button
MODE
Diagnosis Alarm
Current alarm
Parameter error
No.
Point table error
No.
Point table Basic parameters
Point table No.1 Parameter No.0
Point table No.2 Parameter No.1
Point table No.14 Parameter No.18
Point table No.15 Parameter No.19
7 - 1
Expansion parameters
Parameter No.20
Parameter No.21
UP
DOWN
Parameter No.52
Parameter No.53