Mitsubishi melservo-j2 series Instruction Manual page 152

7. DISPLAY AND OPERATION
2) 5-digit parameter
The following example shows the operation procedure performed to change the electronic gear
denominator (parameter No.5) into "12345":
Call the display screen shown after power-on.
Upper 2 digit setting
When changing the parameter No.5 setting, change its set value, then switch power off once and
switch it on again to make the new value valid.
(2) Expansion parameters
To use the expansion parameters, change the setting of parameter No.19 (parameter write disable).
Press once. Select parameter No.5 with
MODE
Press once.
SET
Press once.
MODE
Press once.
SET
The screen flickers.
Change the set value
with or .
UP DOWN
Press once.
SET
The set value is
entered.
Press once.
SET
Press or
UP DOWN
or
UP DOWN
Lower 3 digits setting
.
To the next parameter
7 - 9
.