Installation; Environmental Conditions - Mitsubishi melservo-j2 series Instruction Manual

2. INTRODUCTION

2. INSTALLATION

CAUTION

2.1 Environmental conditions

Environment
Ambient temperature
Ambient humidity
Storage temperature
Storage humidity
Ambient
Altitud
Vibration
• Stacking in excess of the limited number of products is not allowed.
• Install the equipment to incombustibles. Installing them directly or close to
combustibles will led to a fire.
• Install the equipment in a load-bearing place in accordance with this Instruction
Manual.
• Do not get on or put heavy load on the equipment to prevent injury.
• Use the equipment within the specified environmental condition range.
• Provide an adequate protection to prevent screws, metallic detritus and other
conductive matter or oil and other combustible matter from entering the servo
amplifier.
• Do not block the intake/exhaust ports of the servo amplifier. Otherwise, a fault may
occur.
• Do not subject the servo amplifier to drop impact or shock loads as they are
precision equipment.
• Do not install or operate a faulty servo amplifier.
• When the product has been stored for an extended period of time, consult
Mitsubishi.
0 to 55 [°C] (non-freezing)
32 to 131 [°F] (non-freezing)
90%RH or less (non-condensing)
20 to 65 [°C] (non-freezing)
4 to 149 [°F] (non-freezing)
90%RH or less (non-condensing)
Indoors (no direct sunlight)
Free from corrosive gas, flammable gas, oil mist, dust and dirt
Max. 1000m (3280 ft) above sea level
5.9 [m/s ] or less
2
19.4 [ft/s ] or less
2
Conditions
2 - 1