Mitsubishi melservo-j2 series Instruction Manual page 150

7. DISPLAY AND OPERATION
(b) Setting of 5 or more-digit value
The following example gives the after-power-on operation procedure to change the target value of
point table No.1 to "123456":
Setting of upper 3 digits
Press "UP" or "DOWN" after completion of the setting to return to the setting item screen. Further,
press "UP" and "DOWN" together to return to the point table No. display screen.
Press MODE three times. Press UP or DOWN to choose point table No. 1.
Press SET once.
Press SET once.
Press MODE once.
Press SET once.
The screen flickers.
Press UP or DOWN to
change the setting.
Press SET once.
Enter the setting.
Press SET once.
7 - 7
Setting of lower 3 digits