Mitsubishi melservo-j2 series Instruction Manual page 264

REVISIONS
Print Data *Manual Number
Jul.,1998 SH(NA)3179-A
Dec.,1998 SH(NA)3179-B
Mar.,2000 SH(NA)3179-C
*The manual number is given on the bottom left of the back cover.
First edition
Correction of missing pages in Chapters 9 and 13
(1) and (8) added to Instructions for Conformance in CONFORMANCE WITH
EUROPEAN COMMUNITY DIRECTIVES
(1) and (5) added to UL/C-UL STANDARD
(3) changed to short circuit rating
Section 1.3 (1) Rating plate change
Section 3.2 Common line diagram modification
Section 3.6 (2) 2) Lamp load connection diagram modification
Section 3.8.3 CNT added to 6 in encoder connector signal layout diagram
Section 3.9 (3) 1) Change to 60ms for base circuit in timing chart
Section 4.1.2 (2)(h) Sentences added
Section 4.3.2 (3)(b) Table modification, note addition
Section 5.2.7 Selection of communication specifications deleted
Section 6.2 (2)(b) For use of RS-422 added
Section 7.4 (3) (a), (b) and (c) added
Section 7.4 (4) Addition
Section 7.6 Sentence added
Section 8.1.1 (1) General diagram modification
Section 8.1.1 (2) Cable connection diagram modification
Section 8.2.2 Parameter setting added
Section 8.12 Detailed Explanation of Commands changed
Section 8.12.3 (2) Sentences added to Parameter write
Chapter 9 All pages changed
Section 11.2.1 Alarm deactivation added to Alarm and warning list
Section 11.2.2 Deletion of deactivation using alarm reset (RES)
Section 11.2.3 Sentences added
Section 12.2.2 (1) Connectors added
Section 13.4 Addition of encoder cable flexing life
Section 14.1.1 (2) 1) Section 12.1 in sentence is changed to 5.1 in separately
available Servo Motor Instruction Manual
Section 14.1.2 (1) Change to pin 170359-1
Change to connector 10120-6000EL
Change to shell kit 10320-3210-000
Section 14.1.2 (2) 2) Connection diagram modification
Section 14.1.2 (3) Change to connector 10120-6000EL
Change to shell kit 10320-3210-000
Section 14.1.3 POINT added
Section 14.1.5 (2) Diagram modification
Section 14.2.2 Fuse models deleted
Section 14.2.5 (2)(b) Diode installation diagram changed
Section 14.2.5 (5) Connection diagram changed
Section 14.2.9 Analog input setting potentiometer addition
Chapter 15 Deleted
Revision