Panasonic DP-8032 Service Manual page 276

CAUTION! :
<Step sequence of turning OFF the Power Switch>
After the Hard Disk Drive Unit is installed, to prevent a Scan Disk Function from being performed
(similar to when the power is abruptly interrupted to the PC), it is important to follow the step
sequence below when turning OFF the Power Switches on the machine.
1. Turn the Power Switch on the Left Side of the machine to the OFF position first.
2. Wait approximately 10 seconds while the machine writes the closing status onto the Hard
Disk Drive Unit.
3. Turn the Main Power Switch on the Back of the machine to the OFF position.
(This interrupts all the power to the machine)
4. Unplug the AC Power Cord.
<Perform the following steps if the Optional Fax Communication Board (DA-FG300) is also
installed>
<Changing from 200 to 1,000 Station Address Book>
An additional 800 stations (1,000 total) are available when the optional Hard Disk Drive (DA-HD31) is
installed. If you wish to use the 1,000 Fax Address Book, please follow the steps below to change the
address book setting of the machine.
Caution:
• The registered address book data will be deleted when the address book setting is changed.
If your machine already has registered stations in the Fax Address Book, please make a backup first
before changing the address book setting.
• Before changing the Fax Address Book setting, printout the Address Book information or copy the Data
using the Address Book Editor in the Panasonic Document Management System software. After
executing the setting change, re-enter the printed Address Book information or copy and paste the
Data from the 200 to the 1,000 station Address Book file. (See the Operating Instructions for Document
Management System)
Changing the Fax Address Book Setting
Execute the Auto Dial Clear and activate the 1,000 station Address Book by following the steps below.
a) Press the "FUNCTION", "ORIGINAL SIZE (LEDGER/A3)" and "3" keys simultaneously.
b) Input the password, and select the "OK" button to enter the Service Mode (default password is
00000000).
Ver.1.2
(29) Connect the other end of the HD Harness to the
HDD.
(30) Secure the HD Harness with the Harness Clamp
(Metal) and 1 Screw (M3 x 8).
Caution:
Make sure to secure the Shield position of the HD
Harness with the Harness Clamp (Metal).
(31) Proceed with the installation of other options. If
finished, reinstall all Harnesses and Covers.
(32) Plug the AC Power Cord, and turn the Main Power
Switch on the Back and the Power Switch on the Left
Side of the machine to the ON position.
(33) Reconnect the Telephone Line / LAN Cable if
disconnected.
276
DP-8032/8025
2008