Panasonic DP-8032 Service Manual page 175

5.1.3. F4 Mode: Input/Output Status Test
Set the machine to service mode and press "4" key on the Keypad.
↓
Press the "START" key.
↓
Enter the number to activate the test then press "START" key.
↓
Press "STOP" key to cancel the test.
↓
When the "C (CLEAR)" key is touched, the selected code input will not be accepted.
↓
Press "FUNCTION" and "C (CLEAR)" keys simultaneously to exit the service mode.
1. Input Check
No. Function
000 Power Supply Fan Signal
001 LSU Fan Signal
002 Toner Remaining Sensor Signal Toner is detected.
003 Paper Feed Module Detection
Sensor
(2nd Paper Feed Module)
Paper Tray Detection Sensor
(2nd Paper Tray)
Paper Tray Detection Sensor
(1st Paper Tray)
Key / Card Counter Detection
Sensor
NP Sensor
(Sheet Bypass)
Paper Length Sensor
(Sheet Bypass)
Size Sensor 2
(Sheet Bypass, Inside)
Size Sensor 1
(Sheet Bypass, Outside)
Ver. 1.2
F4 Mode (Input Check)
Condition
Normal.
Normal.
Unit is connected.
Paper Tray is not
connected.
Paper Tray is not
connected.
Counter is not detected.
Paper is not detected.
Sensor is activated.
Sensor is activated.
Sensor is activated.
175
Message
Display
7 6 5 4 3 2 1 0
0 (322)
0 (315)
0 (615)
0
---
0 (1045) Fig.23 F6
0 (1045) Fig.11 B5
1
---
1 (1045) Fig.12-1 E8
0 (1045) Fig.12-1 J2
1 (1981)
1 (1981)
DP-8032/8025
Remarks
(Ref.No.)
2008