Error Codes (For Copier) - Panasonic DP-8032 Service Manual

4.6.

Error Codes (For Copier)

The self-diagnostic functions detect troubles in the important components of the copier.
When any trouble occurs, the copier stops.
4.6.1. User Error Codes (U Code)
Note:
Uxx and a message will appear on the Panel Display.
Code
U0 Key Counter
U1 Close Front Cover
U4 Close Finisher
U6 Close Right Cover
U7 Close Feed Cover
U8 Close Paper Transport Unit
U11 Remove Paper in Finisher
U12 Close Finisher Staple Cover / Upper Cover
Ver.1.2
User Error Codes (U Code) Table
Item Possible Cause(s)
1. Key Counter is not installed.
2. Key Counter Harness disconnected.
1. Front Cover open.
2. Front Cover Sensor disconnected.
3. Front Cover Sensor defective
4. LVPS connector disconnected.
5. LVPS defective.
6. SPC PCB connector disconnected.
7. SPC PCB defective.
1. Finisher open.
2. Paper in the output bin.
3. Stapler empty.
4. LVPS connector disconnected.
5. LVPS defective.
6. SPC PCB connector disconnected.
7. SPC PCB defective.
1. Right Cover open.
2. Right Cover Sensor disconnected.
3. Right Cover Sensor defective.
4. LVPS connector disconnected.
5. LVPS defective.
6. SPC PCB connector disconnected.
7. SPC PCB defective.
1. Feed Cover open.
2. Feeder Unit incorrectly installed.
3. Feeder Unit connector disconnected.
4. Feeder Unit Sensor disconnected.
5. Feeder Unit Sensor defective.
6. LVPS connector disconnected.
7. LVPS defective.
8. CST2/CST3 PCB connector disconnected.
9. CST2/CST3 PCB defective.
1. Paper Transport Unit open.
2. Paper Transport Unit Sensor disconnected.
3. LVPS connector disconnected.
4. LVPS defective.
5. SPC PCB connector disconnected.
6. SPC PCB defective.
1. Paper in the Finisher.
2. Finisher Paper Exit Sensor defective.
1. Finisher Staple Cover open.
2. Finisher Staple Cover Sensor disconnected.
3. Finisher Staple Cover Sensor defective.
144
DP-8032/8025
2008