Panasonic DP-8032 Service Manual page 200

5.2.3. Fax Service Mode 1 (Function Parameter Setting)
Use the following procedure to change the function parameters.
Select the "01 Function Param. Setting" on the Touch Panel display.
↓
Select the desired code number on the Touch Panel display.
↓
If you wish to select another code number, scroll the menu with the arrow buttons.
↓
Select the desired function on the Touch Panel display and touch the "OK" button.
↓
Touch the "OK" button 3 times.
↓
Press "FUNCTION" and "C (CLEAR)" keys simultaneously to exit the service mode.
No. Parameter
000 Monitor/Tel Dial
001 Alarm Status
002 Stop Comm.
JRNL
003 Continuous Poll 1 = Off
004 Numeric ID Set
Ver.1.2
Function Parameter Table
Selections
1 = Monitor
2 = Tel/Dial
1 = Off
2 = Timer
3 = Constant
1 = Off
2 = On
2 = Stn (Tx only)
3 = Hub (Rx only)
1 = Off (will not accept)
2 = On (accepts)
Selects whether the machine starts to TX
automatically during On-Hook dialing.
Monitor : Start to TX after pressing START
TEL/DIAL : Start to TX automatically
Selects the No Paper or No Toner alarm status.
OFF : Alarm is disabled.
Timer : Alarm will shut off after 6 seconds.
Constant : Alarm will not stop until "STOP" is
pressed or the error is cleared/
corrected.
Selects whether the machine prompts to print the
COMM. Journal when the printout condition is set to
INC and STOP is pressed during communication.
Selects whether the Continuous Polling feature is
enabled.
Stn : Place the document(s) on the ADF or Platen,
then press the assigned Program Key to
store or add the documents into a polled file.
(See Note 1)
Hub : When the polling command is initiated, the
machine will continuously poll originals from
the remote stations until it is interrupted by
pressing "STOP".
Selects whether the machine accepts and allows to
set or change the Numeric ID.
200
DP-8032/8025
Function
2008