YASKAWA E7U Programming Manual page 127

o1-02 Power-On Monitor
Setting
1 Frequency Reference (factory default)
2 Output Frequency
3 Output Current
4 User Monitor (set by o1-01)
When the Drive is powered up, three monitors are displayed on the digital operator. The first and largest monitor is the
"Power-On" monitor. The factory default "Power-On monitor" is Speed Command (U1-01). Below the Speed Command
monitor are the next two sequential monitors, Output Frequency (U1-02) and Output Current (U1-03). Pressing the INCREASE
key once scrolls the monitors to show the User Monitor as selected by o1-01. The factory default for o1-01 is the Output Voltage
monitor (U1-06).
The active monitor displayed when the Drive is powered on can be changed to either be U1-01 (Speed Command), U1-02
(Output Frequency), U1-03 (Output Current), or the User Monitor. Whichever monitor is selected as the Power-On top monitor,
the two monitors displayed below it are the next two sequential monitors. See example below.
Active Monitor
For example, if the Drive needs to display the Elapsed Timer as the Power-On monitor, then o1-01 must be set to "13" and
o1-02 must be set to "4". The next time Drive power is cycled, the digital operator displays U1-13 (Elapsed Time), U1-14 (Flash
ID), and U1-15 (Term AI Level).
Active Monitor
Description
-DRIVE-
Frequency Ref
U1-01= 60.00Hz
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
U1-02= 60.00Hz
U1-03= 10.05A
-DRIVE-
Elapsed Time
U1-13=
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
U1-14= 03010
15
U1-16= 51.2%
Programming 121
Rdy
Output Frequency
Output Current
Rdy
2
H
Flash ID
Term AI Level
Active Monitor Title
Next two
sequential
monitors
Active Monitor Title
Next two
sequential
monitors