YASKAWA VS MINI J7 Instruction Manual
Vs mini j7 series compact general-purpose inverter (voltage vector control)
Hide thumbs
Also See for VS MINI J7:
- Instruction manual (138 pages) ,
- Replacement instructions manual (16 pages) ,
- Connection manual (64 pages)
Related Manuals for YASKAWA VS MINI J7
Summary of Contents for YASKAWA VS MINI J7
- Page 15 !!!!
- Page 16 !!!!
- Page 17 !!!!
- Page 18 !!!!
- Page 19 !!!!
- Page 20 !!!!
- Page 24 2.68 (68) 5.04 (128) 2.76 (70) 2.20 (56) 4.65 (118) 2.68 (68) 5.04 (128) 2.76 (70) 2.20 (56) 4.65 (118) 2.68 (68) 5.04 (128) 4.02(102) 2.20 (56) 4.65 (118) 2.68 (68) 5.04 (128) 4.80(122) 2.20 (56) 4.65 (118) 4.25 (108) 5.04 (128) 5.08 (129) 3.78 (96)
- Page 26 230V (Note 1)
- Page 39 !! !!! !! !!! !! !!!
- Page 44 " "...
- Page 51 51 and 52...
- Page 52 Parameter Parameter No. (Refer to page 57)
- Page 100 AIR FLOW DIRECTION...
- Page 104 (Green) (Red)
- Page 105 (Green) (Red)
- Page 106 (Green) (Red)
- Page 107 (Green) (Red)
- Page 108 (Green) (Red)
- Page 109 (Green) (Red)
- Page 110 (Green) (Red)
- Page 111 Appendix - CE Conformance CE Conformance - Low Voltage Directive (LVD) Compliance • These circuits are hazardous and are separated from accessibility by protective separation. ‚ These circuits are not separated from hazardous circuits by protective separation, but only with basic insulation. These circuits cannot be accessed and must not be interconnected with any circuits which are accessible, unless they are isolated from accessible circuits by supplemental insulation.
- Page 112 The following table and figures show the line filter list for EMC standards and the installation/wiring of inverter and line filter. Line Filter List for EMC Conformance Recommended Line Filters for VS mini J7 made by Rasmi Electronics Ltd (200V single phase) Current...
- Page 113 Recommended Line Filters for VS mini J7 made by Rasmi Electronic Ltd (200 V three phase) Current Weight Dimension VS mini J7 Model (kg) W D H CIMR-J7AU20P1 CIMR-J7AU20P2 RS 2010-J7 82 x 50 x 194 CIMR-J7AU20P4 CIMR-J7AU20P7 CIMR-J7AU21P5 RS 2020-J7...
- Page 114 Installation of Line Filter and Inverter VS mini J7 (CIMR-J7 ¨¨20P1 to 23 P7) L1 L2 L3 P E Shield Cable Control Panel Rasmi Filter R S T Ground VS mini Bonds (remove paint) U V W Shield Cable Ground Bonds (remove any paint) Max.20m...
- Page 115 Installation of Line Filter and Inverter VS mini J7 (CIMR-J7 ¨¨B0P1 to B1P5) Shield Cable Control Panel Metal Rasmi Mounting Plate Filter Ground Bonds VS mini (remove paint) U V W Shield Cable Ground Bonds (remove any paint) Max.20m Motor Cable...
- Page 116 This also applies for equipment with CE approvals. Compliance with the EMC legislation limits is the responsibility of the machine or system manufacturer. RCCBs For information on the use of RCCBs with inverters please contact your supplier or Yaskawa representative. Operation In some systems it may be necessary to install additional monitoring and protective facilities to comply with the applicable safety and accident prevention regulations.
- Page 117 Responsibility As a component manufacturer we are responsible for the provision of installation instructions. These can be found in the installation guidelines publication G-TI#99012-V7 (a Yaskawa publication free upon request). Our products have been tested by authorized bodies pursuant to the requirements of the standard listed below.
- Page 118 YASKAWA ELECTRIC AMERICA, INC. Chicago-Corporate Headquarters 2121 Norman Drive South, Waukegan, IL 60085, U.S.A. Phone: (847) 887-7000 Fax: (847) 887-7310 Internet: http://www.yaskawa.com MOTOMAN INC. 805 Liberty Lane, West Carrollton, OH 45449, U.S.A. Phone: (937) 847-6200 Fax: (937) 847-6277 YASKAWA ELECTRIC CORPORATION New Pier Takeshiba South Tower, 1-16-1, Kaigan, Minatoku, Tokyo, 105-0022, Japan Phone: 81-3-5402-4511 Fax: 81-3-5402-4580 Internet: http://www.yaskawa.co.jp...