Copying From The Bypass Tray - Ricoh AFICIO MP 8000 Operating Instructions Manual

Copying from the Bypass Tray

The bypass tray allows you to copy non-standard paper.
Important
❒ The Duplex function cannot be performed on paper fed from the bypass tray.
If [1 Sided→2 Sided] is selected, cancel the setting. You can also change the ini-
tial settings. You can change the initial settings. See "Programming Defaults
in Initial Display".
❒ Paper has a vertical length of 100-305 mm (3.9-12 inches) and a horizontal
length of 139.7-600 mm (5.5-23.6 inches) can be copied from the bypass tray.
❒ The machine can automatically detect the following sizes as standard size
copy paper:
• Metric version: A3L, A4L, A5L
• Inch version: A3L, 11" × 17"L, 8
❒ If you want to use the size of paper other than the above, be sure to specify
the size.
❒ When copying on OHP transparencies or paper heavier than 105 g/m
27.9 lb.), you need to specify the type and size of paper with "Special Original".
❒ The maximum number of sheets you can load into the bypass tray depend on
paper type. Load only as much paper as can be held between the paper guides
on the bypass tray.
❒ When paper larger than 433 mm (17.1 inches) in size is used, the paper may
become wrinkled, may not be fed into the machine, or may cause paper jams.
❒ When copying onto special paper such as adhesive labels, always select "Face
Up". If you select "Face Down", a paper misfeed may occur.
❒ If you place originals on the exposure glass and want the copies to be deliv-
ered face down, select "Face Down" for both "Copy Eject Face Method in
Glass Mode" and "Copy Eject Face Method in Bypass Mode" of User Tools.
❖ [Bypass Tray Usage]
Press [Bypass Tray Usage] to display a description on using the bypass tray.
Copying from the Bypass Tray
" × 14"L, 5 " × 8
1 1
/ /
2 2
1
/ "L
2
2
(about
2
37