Command Interpreter Mode; Boot Module Commands - ZyXEL Communications Prestige 642 User Manual

Initial Remote
Directory.
Initial Local
Directory.

10.10 Command Interpreter Mode

This option allows you to enter the command interpreter mode. A list of valid commands can be found by
typing [help] at the command prompt. For more detailed information, check the ZyXEL Web site or send e-
mail to the ZyXEL Support Group.
Copyright (c) 1994 - 1999 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys exit
wan ip
ipx hdap

10.11 Boot module commands

Prestige boot module commands with accompanying explanations are shown in the following table. For
ATBAx, x denotes the number preceding the colon to give the console port speed following the colon in the
list of numbers that follows; e.g. ATBA3 will give a console port speed of 9.6 Kbps. ATSE displays the
seed that is used to generate a password to turn on the debug flag in the firmware. The ATSH command
shows product related information such as boot module version, vendor name, product model, RAS code
revision, etc.
System Maintenance
mode.
Specify the default remote directory (path).
Specify the default local directory (path).
Enter Menu Selection Number: 8
device
ppp
Figure 10-22 Command mode
Prestige 642 ADSL Internet Access Router
ether
bridge
10-19