Displaying Port Operation Parameters - HP 1910 User Manual

Item
Selected Ports
NOTE:
If you set operation parameters that a port does not support, you are notified of invalid settings and may
fail to set the supported operation parameters for the port or other ports.

Displaying port operation parameters

Displaying a specified operation parameter for all ports
Select Device > Port Management from the navigation tree to enter the Summary page by default.
1.
Click the button of a parameter you want to view and the parameter information for all the ports
2.
is displayed in the lower part of the page, as shown in
Figure 60 The Summary tab
Displaying all the operation parameters for a port
Select Device > Port Management from the navigation tree
1.
Description
Interface or interfaces that you have selected from the chassis front panel and the
aggregate interface list below, for which you have set operation parameters.
IMPORTANT:
You can set only the state and MAC learning limit for an aggregate interface.
Figure
28
60.