HP 1910 User Manual page 175

Figure 149 Creating a VLAN interface
Configure the VLAN interface as described in
3.
Click Apply.
4.
Table 43 Configuration items
Item
Input a VLAN ID:
DHCP
BOOTP
Configure
Manual
Primary
IPv4
IPv4
Address
Address
Mask
Length
Auto
Configure
IPv6 Link
Local
Address
Manual
Description
Enter the ID of the VLAN interface to be created. Before creating a VLAN interface,
make sure that the corresponding VLAN exists.
Configure the way in which the VLAN interface gets an IPv4 address.
Allow the VLAN interface to obtain an IP address automatically by
selecting the DHCP or BOOTP option, or manually assign the VLAN
interface an IP address by selecting the Manual option.
Configure an IPv4 address for the VLAN interface.
This field is available after you select the Manual option.
Set the subnet mask length (or enter a mask in dotted decimal
notation format).
This field is available after you select the Manual option.
Configure the way in which the VLAN interface obtains an IPv6
link-local address.
Select the Auto or Manual option:
•
Auto—The device automatically assigns a link-local address for
the VLAN interface based on the link-local address prefix
(FE80::/64) and the link-layer address of the VLAN interface.
•
Manual—Requires manual assignment.
114
Table 43.
These items
are available
after you
select the
Configure
Primary IPv4
Address box.
These items
are available
after you
select the
Configure
IPv6 Link
Local