Igmp Snooping Configuration Example - HP 1910 User Manual

IGMP snooping configuration example

Network requirements
As shown in
acts as the IGMP querier.
Perform the configuration so that Host A can receive the multicast data destined for the multicast group
(224.1.1.1), and Switch A drops the unknown multicast data rather than flooding it in the VLAN.
Figure 245 Network diagram
1.1.1.1/24
1.1.1.2/24
Source
Configuring Router A
Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on Ethernet 1/1.
(Details not shown.)
Configuring Switch A
Create VLAN 100:
1.
Select Network > VLAN from the navigation tree.
a.
Click the Create tab.
b.
Enter 100 as the VLAN ID.
c.
Click Apply.
d.
Figure 245, IGMPv2 runs on Router A and IGMPv2 snooping runs on Switch A. Router A
Eth1/2 Eth1/1
10.1.1.1/24
Router A
IGMP querier
Host B
GE1/0/2
GE1/0/1 GE1/0/3
Switch A
237
VLAN 100
Host A
Receiver