HP 1910 User Manual page 310

Figure 256 Advanced configuration
Configure the parameters as described in
3.
Click Apply.
4.
Table 89 Configuration items
Item Description
Select the port on which advanced MLD snooping features will be configured. The port
can be an Ethernet port or Layer-2 aggregate port.
After a port is selected, advanced features configured on this port are displayed at the
lower part of this page.
Port
Advanced MLD snooping features configured on a Layer 2 aggregate port do not interfere
with features configured on its member ports, nor do they take part in aggregation
calculations; features configured on a member port of the aggregate group will not take
effect until it leaves the aggregate group
Specify a VLAN in which you can configure the fast-leave function for the port or the
maximum number of IPv6 multicast groups allowed on the port.
VLAN ID
Configurations made in a VLAN take effect for the ports in this VLAN only.
Configure the maximum number of IPv6 multicast groups that the port can join.
With this feature, you can regulate IPv6 multicast traffic on the port.
Multicast Group
Limit
When the number of IPv6 multicast groups a port has joined reaches the configured
threshold, the system deletes all the IPv6 forwarding entries persistent on that port from the
MLD snooping forwarding table, and the hosts on this port need to join the IPv6 multicast
groups again before the number of IPv6 multicast groups on this port reaches the threshold.
TIP:
IMPORTANT:
249
Table 89.