Removing The Hood - Toro workman HDX-D 07368 Operator's Manual

Figure 39
1. Rear jacking points

Removing the Hood

1. While grasping the hood in the headlight openings,
lift up on the hood to release the lower mounting
tabs from the frame slots (Figure 40).
Figure 40
1. Hood
2. Pivot the bottom of the hood upward until the top
mounting tabs can be pulled from the frame slots
(Figure 40).
3. Pivot the top of hood forward and unplug the wire
connectors from the head lights (Figure 40).
4. Remove the hood.
To install the hood, complete the following:
1. Connect the lights.
2. Insert the top mounting tabs into the frame slots.
3. Insert the lower mounting tabs into the frame slots.
4. Ensure that the hood is fully engaged in the top,
sides and bottom grooves.
39