1. Front jacking points
1. Rear jacking points
Removing the Hood
1. While grasping the hood in the headlight openings, lift
up on the hood to release the lower mounting tabs
from the frame slots (Figure 35).
Figure 33
Figure 34
1. Hood
2. Pivot the bottom of the hood upward until the top
mounting tabs can be pulled from the frame slots
(Figure 35).
3. Pivot the top of hood forward and unplug the wire
connectors from the head lights (Figure 35).
4. Remove the hood.
To install the hood, complete the following:
1. Connect the lights.
2. Insert the top mounting tabs into the frame slots.
3. Insert the lower mounting tabs into the frame slots.
4. Ensure that the hood is fully engaged in the top, sides
and bottom grooves.
34
Figure 35