Table of Contents
Advertisement
14
ELECTRICAL SYSTEM
14.11
Checking the headlight setting
A
0 0 A
14.12
Adjusting the headlight range
14.13
Changing the speedometer battery
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
B
0 0 B
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range of the headlight by moving it up or down.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
101404-10
A change in weight on the vehicle may require a correction of the headlight
range.
–
Tighten screw
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Pull the speedometer out of the bracket from above.
101405-10
–
Using a coin, turn locking cap
–
Remove speedometer battery
–
Insert the new battery with the label facing upward.
Speedometer battery (CR 2430) (
–
Check that the O-ring of the locking cap is seated properly.
101406-10
under the first mark.
B
B
A
p. 89)
.
1
.
1
.
1
counterclockwise all the way and remove it.
2
.
3
5 cm (2 in)
away from the wall.
A
5 m (16 ft)
p. 89)
p. 87)
p. 110)
89
Advertisement
Table of Contents
