Singer 560 Operation Manual page 102

t-'--..==-~
111111111111111111111111111111111111
B
A•n•uuuunn•nuuuu•u•nu•
0
~~~~~~~~~~~~ ~
\\\1 \\II \1 \1
~II
I I
I I ~~
fl f;
f ~
r
r1
~ ~ ~
[
f
r1
fl~ ~ fl~
fl
~ ~ ~
fJ
~ [/~ [/~~ fl@~~
~ ~~ ~\
r r
7. Disconnect Ribber Carriage from Arm. Move Ribber
Carriage from the left to the right removing stitches
on Ribber, then remove the Carriage from Needle Bed.
8. Push Ribber needles to A position using Needle Pusher.
9. Insert End Stitch Holders under Ribber needles as far
as they go at both ends of fabric as shown on the left.
By setting the Holders, both end stitches of fabric and
the yarn are pressed against Knitter Sinker Posts.
Place End Stitch Holder 1-2 needles off the end of
fabric as illustrated below. If you place the bent portion
of the Holder under needles in 8 position, Yarn Feeder
and needles may be damaged.
10. Knit three rows in waste yarn using Knitter Carriage.
Exchange waste yarn for main yarn and knit two rows
leaving Carriage at the right side.
11. Place the contrast yarns into Holders of YC and arrange
their positions.
12. Raise the Driving Lever and knit one row from the right
to the left reaching the yarn changer.
13. Push OFF the Inspection Button.
14. With the Cam Lever at the position you desire
(0,
Tor
S), start to knit changing yarns by pushing the Holder
Buttons at the row you desire.
- 98 -