Waste Ink Pads - Epson Stylus NX510 Service Manual

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
2. Release the PF Roller from the cutout of the Base Frame (Step 2-1), and
remove the PF Roller (Step 2-2)
Step 2-1
Figure 4-107. Removing the PF Roller (2)
NX510 series only:
Install the PF Roller after attaching the Grounding Spring as
shown in the figure below.
PF Roller
Figure 4-108. Installing the PF Roller
Whenever the PF Roller, is removed/replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
Chapter 5 " ADJUSTMENT" (p.161)
•
After replacing the Front Paper Guide, be sure to perform the
required lubrication.
Chapter 6 " MAINTENANCE" (p.175)
•
DISASSEMBLY/ASSEMBLY
PF Roller
Step 2-2
Grounding Spring
Disassembling the Printer Mechanism

4.5.20 Waste Ink Pads

Parts/Components need to be removed in advance
Document Cover/ASF Cover/Scanner Unit/Panel Unit/Upper Housing/Card Slot
Cover/Lower Housing/Main Board Unit/Left Frame/Front Frame/Right Frame/CR
Motor/CR Scale/Hopper/Main Frame Assy/ASF Unit/Ink System Unit/Star Wheel
Holder Assy/EJ Roller/Front Paper Guide/PF Encoder Sensor/PF Scale/PF Roller
Removal procedure
In this section, some disassembling procedures differ between
C H E C K
models. Skip the model-specified steps if not applied to your
P O I N T
model.
1. Remove the Waste Ink Pads shown below from the A, B, and C sections of the
Base Frame.
Waste Ink Pads
Section A
Section B
Section C
A
Figure 4-109. Removing the Waste Ink Pads
Revision A
NX510 series SX410/SX210 series
2 pieces 2 pieces
3 pieces 2 pieces
1 piece 1 piece
B
C
Confidential
139