Lubrication - Epson Stylus NX510 Service Manual

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510

6.1.3 Lubrication

The type and amount of the grease used to lubricate the printer parts are determined
based on the results of the internal evaluations. Therefore, be sure to apply the
specified type and amount of the grease to the specified part of the printer mechanism
on the following occasion.
Any parts required the lubrication are replaced.
The printer is disassembled/assembled. (If necessary)
Never use oil or grease other than those specified in this
C A U T I O N
manual. Use of different types of oil or grease may damage the
component or give bad influence on the printer function.
Never apply larger amount of grease than specified in this
manual.
Table 6-1. Specified Lubricant
Type Name
Grease
G-45
Grease
G-71
Grease
G-74
MAINTENANCE
Supplier
EPSON Code
1033657 EPSON
1304682 EPSON
1409257 EPSON
Overview
Refer to the following figures for the lubrication points.
Driven Pulley
Driven Pulley Holder
Front Driven Pulley
Back
Figure 6-1. Lubrication on Driven Pulley
Revision A
<Lubrication Point>
1. Shaft hole of the Driven Pulley
2. Two contact points between the
Driven Pulley Holder and the
Driven Pulley Shaft
3. Contact points (x9) with the
Main Frame.
<Lubrication Type>
G-71
<Lubrication Amount>
φ 1 mm x 1 mm
<Remarks>
Use an injector to apply G-71.
177
Confidential