Setup Mode - Epson Stylus NX510 Service Manual

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
1.7.5.3 How to Place Silver Halide Pictures
The following explains how to place silver halide film-based pictures on the document
glass of the printer.
Available picture size: 30x40 mm to 127x178mm (5"x7")
Lay the pictures on the glass face down.
The number of pictures available at one time is as follows:
• 4x6 or smaller:up to 2 pictures
• 5x7: up to 1 picture
The following spaces are needed:
• 5 mm or more space from the right and front edges of the document glass.
• 5 mm or more space between pictures.
The pictures must not be tilted.
Document
Glass
5mm
Figure 1-12. Laying Silver Halide Pictures
PRODUCT DESCRIPTION
5mm
Picture (2)
5 mm or more
Picture (1)
Scanning Direction
Home position
Specification for Each Function

1.7.6 Setup Mode

NX510/SX410 series turns into the Setup mode by pressing the [Setup] button, and
each setting and maintenance become available. For SX210 series, simultaneously
pressing the [Index sheet] button and the [Scan] button provides the same function.
Table 1-53. NX510/SX410 series Common Setup Mode Menu
Item
The current ink levels are displayed in bar chart by the rules
described below. After displaying the ink levels, the next
operation can be selected from the following two options;
"OK" or "Replace Cartridge".
• The bar chart is displayed in the order of black, magenta,
yellow, and cyan from the left.
Ink Cartridge Status • When initial filling is completed, or after replacing the
cartridge, the ink level becomes 100% (full).
• The ink level is indicated in increment of 1%. Lower than
1% is rounded up.
• When the remaining ink level becomes lower than
approximately 10%, zero (ink low status) will be
displayed.
Runs various maintenance for the printer. The following
shows each menu.
• Nozzle Check
A nozzle check pattern to check the Printhead nozzles
status is printed. A head cleaning can be run if necessary.
(Refer to
• Head Cleaning
Runs a printhead cleaning. The cleaning cannot be made
when low ink level is detected.
Maintenance
• Head Alignment
Adjustment to improve the bi-directional print quality.
Head alignment icon and the instructions for the
adjustment are displayed on the LCD.
• Cartridge Replacement
Runs an ink cartridge replacement sequence. This can be
done from the Ink Cartridge Status menu or by following
the instructions on the LCD when an ink-related error
occurs.
Revision A
Function
Figure 1-13, Figure 1-14 for Printout patterns.)
Confidential
44