Removing The Waste Ink Pads - Epson Stylus Photo R340 Service Manual

EPSON Stylus Photo R340/350

2.3.17 Removing the Waste Ink Pads

Illustration
Small Waste Ink Pads
(on both the upper and
lower sides)
Lower Small Cap Ink Pad
(on the Upper Side)
Figure 2-63. Removing the Waste Ink Pads
Disassembly and Assembly
Upper Waste Ink Pad
Lower Waste Ink Pad
Lower Large Cap Ink Pad
(on the Lower Side)
Parts/Components must be removed to remove the Waste Ink Pads.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing,
Rear Housing, Main Board Assy., ASF Assy., Shaft Assy. Holder,
Printer Mechanism, Power Supply Assy.
Disassembly Procedure
1. Remove the six Waste Ink Pads from the Lower Housing.
Reattach the six Waste Ink Pads so that their holes are properly set
onto the ribs ( ), guide pins ( ) and tabs ( ) on the Lower
Housing.
Bottom Side
Top Side
Figure 2-64. Reinstalling the Waste Ink Pads
Whenever the Waste Ink Pads are replaced, be sure to perform the
A D J U S T M E N T
R E Q U I R E D
required adjustment shown below. (See Chapter 3 for details on the
adjustments)
Protection counter
Disassembly
Revision A
Bottom Side
Top Side
75