Printhead (Sx210 Series) - Epson Stylus NX510 Service Manual

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
When installing each button, securely engage the hooks, or
align the dowels and the positioning holes correctly. After
assembling them, press all the buttons to confirm they sure
click. (See Figure
When installing the LCD Unit, insert the ribs (x2) of LCD
Unit into the holes (x2) on the Panel Housing, and attach it
while aligning the positioning holes and pins. (See
4-151.)
When installing the Panel Board A/B, attach them while
aligning the positioning holes (x4) and the pins (x4). (See
Figure 4-150.)
When connecting the LCD FFC to the Panel Board B, lock
the connector (CN2) securely. (See
Tighten the screws in the order given in
the screw # 8, secure the grounding wire together.
When connecting the Panel FFCs (x2), align them with the
marking on Panel Board Frame, and secure them with
double-sided tape to the locations shown in
When attaching the grounding wire, make sure to put the
soldered section to the front of the printer, and secure it with
the screw. (See Figure
When installing the Panel Unit, attach it without any gap with
the Upper Housing. (See
DISASSEMBLY/ASSEMBLY
4-152.)
Figure
Figure 4-150.)
Figure 4-149. As for
Figure 4-148
4-147.)
Figure 4-30.)
Differences in Disassembling/Reassembling SX210 series

4.8.3 Printhead (SX210 series)

See the following because the disassembling/reassembling
C H E C K
procedures of the Printhead for NX510/SX410 series differ from
P O I N T
those of SX210 series.
NX510 series:
" 4.5.1 Printhead " (p113)
SX410 series:
" 4.7.3 Printhead (SX410 series) " (p150)
Parts/Components need to be removed in advance
Document Cover/ASF Cover/Scanner Unit/Panel Unit/Upper Housing
Removal procedure
1. Perform Step 1 to Step 8 of "4.5.1 Printhead
2. Remove the Head Cable Inner Cover according to the following procedure.
2-1. Release the cutout (x1) of the Head Cable Inner Cover from the hook
(x1) of the CR Unit.
2-2. Release the tab (x1) of the Head Cable Inner Cover from the groove
(x1) of the CR Unit.
2-3. Release the rib of the Head Cable Inner Cover from the cutout of the
CR Unit.
Cutout and
Hook Step 2-1
Step 2-2 Tab and groove
Figure 4-153. Removing the Sub FFC Guide
Revision A
(p113)".
Head Cable Inner Cover
Cutout Step 2-3
Rib
Confidential
158