Epson Stylus NX510 Service Manual page 159

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
Do not touch or damage the nozzles or the ink supply needles of the
C A U T I O N
Printhead.
3. Remove the screws (x3) that secure the Printhead, and lift the Printhead with
longnose pliers.
Figure 4-154. Removing the Printhead (1)
4. Disconnect the Head FFC from the connectors (x2) of the Printhead, and
remove the Printhead.
Head FFC
Figure 4-155. Removing the Printhead (2)
DISASSEMBLY/ASSEMBLY
1 2
3
C.B.S. 2.5x8, F/Zn-3C (3±1kgfcm)
Positioning Hole and Dowel
Printhead
Differences in Disassembling/Reassembling SX210 series
When installing the Printhead, attach it while aligning the
positioning holes (x2) on the Printhead and dowels (x2) on the
CR Unit.
Tighten the screws in the order given in
Insert the Holder Board Assy vertically into the CR Unit so as
not to put the Holder Board Assy on the rib of the Printhead.
Whenever the Printhead is removed/replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
• Chapter 5 " ADJUSTMENT" (p.161)
Revision A
Figure 4-138.
159
Confidential