Epson Stylus NX510 Service Manual page 136

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510
For NX510 series:
Place the tube with a red line to the rear as shown below, and
•
route the waste ink tubes (x2) without any twisting.
Waste Ink Tube
Red line
Figure 4-98. Routing the Waste Ink Tube
Attach the Tube Stopper to the Waste Ink Tube as shown in
•
the figure below, and insert them into the Waste Ink Cover.
Tube Stopper
Figure 4-99. Installing the Waste Ink Tube
• When inserting the Waste Ink Tube into the Waste Ink
Cover, make sure that there is no gap between the Tube
Stopper and Waste Ink Cover.
DISASSEMBLY/ASSEMBLY
7
Groove Groove
Blue line
Align the blue markings of
Waste Ink Tube with the edge
of the hook (the one from the
rear side of the printer) on the
Ink System.
36 ± 1mm
Waste Ink Tube
36 ± 1mm
Disassembling the Printer Mechanism
For SX410/SX210 series:
Route the Waste Ink Tube through the groove of the Base
•
Frame so that the red line of the Waste Ink Tube faces to the
Ink System Unit side.
Waste Ink Tube
Groove
Figure 4-100. Routing the Waste Ink Tube
Attach the Tube Stopper to the Waste Ink Tube as shown in
•
the figure below, and insert them into the Waste Ink Cover.
Tube Stopper
Figure 4-101. Installing the Waste Ink Tube
When inserting the Waste Ink Tube into the Waste Ink
•
Cover, make sure that there is no gap between the Tube
Stopper and Waste Ink Cover.
Revision A
Waste Ink Tube
136
Confidential