Xcp 1121 Issues And Workarounds - Fujitsu SPARC Enterprise M3000 Product Notes

M8000/M9000 servers:
■
Do not use the internal CD-RW/DVD-RW drive unit and the TAPE drive unit at
the same time.
When you use the external power control interface of the external power
■
controller, the following notification signals are not supported:
■
■
M8000/M9000 servers:
■
On the M8000/M9000 servers with XCP 1050 or later, the dual XSCF Unit feature
is working. Therefore, you can not downgrade M8000/M9000 servers with XCP
1050 or later to XCP 1040 or XCP 1041, which does not support dual XSCF Unit
feature.
You cannot use the following user account names, as they are reserved for system
■
use: root, bin, daemon, adm, operator, nobody, sshd, rpc, rpcuser, ldap,
apache, ntp, admin, proxyuser, and default.
XSCF-LAN is compliant with auto-negotiation. When you connect XSCF-LAN
■
and the network device which has been fixed to the full-duplex mode, according
to the IEEE 802.3 rule, XSCF-LAN communicates in the half-duplex mode. Due to
this, network communication speed may slow down or communication error may
occur. Do not fail to set the network device which connects with XSCF-LAN to the
auto-negotiation mode.
M4000/M5000/M8000/M9000 servers:
■
While you are performing DR operation to a COD board, do not execute the
addcodactivation(8)/addcodlicense(8)/deletecodactivation(8)/
deletecodlicense(8)/setcod(8) command.
At this time the -e, -l, -P options of the snapshot(8) command are not
■
supported.
An XSCF user account user name cannot match an LDAP user name, and an
■
XSCF user account number (UID) cannot match an LDAP UID number.
In case that any failure occurred on a system board and failed to read the FRU
■
information of system board, XSCF regards the system board as a COD board.
The showboards -va command displays the COD status as "y." In this case,
replace the failed system board.

XCP 1121 Issues and Workarounds

For known XCP issues and possible workarounds in XCP 1121, see
and Workarounds in XCP 1121" on page
"XCP Issues Fixed in XCP 1121" on page
14 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1121 • February 2016
The OS panic or the server hardware error signal (*CPUN/RTNU)
The server hardware error signal (power fail, temperature error, and fan error)
(*ALARM)
18. For fixed XCP issues in XCP 1121, see
23.
"Known Issues