Xcp Issues Fixed In Xcp 1121; Xcp Issues Fixed In Releases Earlier Than Xcp 1121 - Fujitsu SPARC Enterprise M3000 Product Notes

XCP Issues Fixed in XCP 1121

TABLE 3-2
XCP Issues Fixed in XCP 1121
TABLE 3-2
M4000
ID M3000 M5000
RTIS1- O O
151212-001
XCP Issues Fixed in Releases Earlier Than XCP
1121
TABLE 3-3

XCP Issues Fixed in Releases Earlier Than XCP 1121

TABLE 3-3
M4000
ID M3000 M5000
RTIF1- O
070418-004
RTIF1- O
070418-005
lists XCP issues fixed in XCP 1121.
M8000
M9000 Description
O If the SNMP Agent Status setting was
changed when in the enable state,
SNMP Agent Status becomes disable.
You can check Agent Status from the
Agent Status display of the
showsnmp command.
lists XCP issues that have been fixed in releases earlier than XCP 1121.
M8000
M9000 Description
O All domains must be powered off
before upgrading the XCP.
O If you log in to the XSCF while it is
still booting, you may get a bash$
prompt instead of the XSCF> prompt,
and be unable to perform most
operations.
Workaround
After changing the SNMP Agent
Status setting once to disable with the
setsnmp command, set Agent Status
to enable with the setsnmp command.
Workaround
Power off domains before using the
flashupdate(8) command to
upgrade XCP firmware.
Log out of the bash$ prompt and
wait for the XSCF to finish booting.
Chapter 3 Information About Software 23