Support For Windows 7 And Internet Explorer 8; New Information About Known Issues - Fujitsu SPARC Enterprise T5120 Product Notes

When building or deleting a RAID 1 array
■
When you build or delete a RAID array, do not fail to make backup copies of
■
the data. When rebuilding a RAID, you need to restore data from the backup
media.
The RAID build or the synchronization associated with maintenance takes
■
about an hour for a 146GB HDD.
If there is a system restart during the RAID build or synchronization, the
■
build/synchronization must be started again from the beginning.
When the RAID applied, the volume size is smaller than the size of original
■
disk.
During the RAID 1 operation
■
Preventive maintenance while the system is running is not available.
■
In some cases, RAID controller cannot conclude the disk is completely in
failure, and system slowdown may occur. To do maintenance in this status, it
becomes necessary to rebuild the RAID 1 and to restore the data from the
backup media.
Notes on the raidctl command
■
Do not use the following options of the raidctl command, which are not
■
supported.
raidctl -C -r 1E
raidctl -c -r 1E
raidctl -a
raidctl -p
The following option of the raidctl command cannot be used.
■
raidctl -C -z

Support for Windows 7 and Internet Explorer 8

As of ILOM 3.0.9, the Remote Console feature in ILOM supports Microsoft Windows
7 and Internet Explorer 8 operating system clients.

New Information About Known Issues

This section describes issues that were discovered since the previous edition of these
product notes was published.
Chapter 1 New Information About the SPARC Enterprise T5120 and T5220 Servers 5