Fujitsu SPARC Enterprise M3000 Product Notes page 68

XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1- O O
121112-003
RTIF1- O O
121112-004
RTIF1- O
121112-005
RTIS1- O O
130218-004
RTIF1-
120329-002
52 SPARC Enterprise Mx000 Servers Product Notes for XCP Version 1121 • February 2016
M8000
M9000 Description
O After the getflashimage -v
command execution, the URI of the
send file and the receive file in
transfer from 'A' to 'B' is displayed
vice versa.
O After the fmdump(8) command
execution, the FRU information of
each event may fail to display the last
one character in part, serial, and
revision.
O In the following configuration, active
replacement or active addition of a
PCI card may fail. On this occasion,
Ap_Id format and devices may not be
shown correctly by cfgadm(1M).
M4000/M5000 servers:
• Active addition of a PCI card to
PCIE#1
• Active addition of a PCI card to a
PCI slot on the External I/O
Expansion Unit
• Active replacement or active
addition of a link card on PCIE#1
which is connected with the
External I/O Expansion Unit
M8000/M9000 servers:
• Active addition of a PCI card to a
PCI slot on the External I/O
Expansion Unit
O After updating the firmware, the Fault
Management MIB Trap might not be
reported.
O M9000 server:
When using the expansion cabinet,
the depleted life (lifetime) of the
energy storage module (ESM) on a
Sun Flash Accelerator F20 PCIe card
might be inaccurately reported or
cannot be displayed. A depleted ESM
might not be reported.
Workaround
No workaround is available.
Read the URI display of the send file
and the receive file in reverse order.
No workaround is available.
When the FRU at the time of event
occurrence is mounted, you can use
the showhardconf(8) command to
confirm the FRU information.
In the relevant configuration, stop the
domain and perform cold addition or
cold replacement and then start the
domain.
To add a PCI card to the
M4000/M5000 servers, perform the
active addition of a PCI card to a slot
other than PCIE#1.
To restore, reboot the domain.
Execute the following command or
reset the XSCF.
XSCF> setsnmp disable
XSCF> setsnmp enable
No workaround is available.