Fujitsu SPARC Enterprise M3000 Product Notes page 45

XCP Issues Fixed in Releases Earlier Than XCP 1121 (Continued)
TABLE 3-3
M4000
ID M3000 M5000
RTIF1- O
070904-002
RTIF1- O
070904-003
RTIF1- O
070904-005
RTIF1- O
070904-006
RTIF1- O
070912-001
M8000
M9000 Description
O When the snapshot CLI attempts to
write to a USB stick that has write
protect set results in an I/O error.
O An incorrect domain state is reported.
After the command sendbreak(8) to
domain is issued,
showdomainstatus(8) continues to
show the state as "Running" when the
domain is actually at "ok" prompt.
O Time can't be synchronized with the
NTP server.
O While executing the domain power-
on, domain reset or DR, in case the
XSCF reset occurred, the process may
be aborted in some or all of the XSB.
O If an invalid SMTP server is
configured, a subsequent attempt to
disable e-mail service (using the
setemailreport CLI) may block for
up to 30 minutes.
Workaround
Do not attempt to use write-protected
USB devices for collecting snapshot.
No workaround is available. This is
expected behavior of the
sendbreak(8) operation.
Check the stratum value of the NTP
server.
The stratum value of XSCF is "5." The
NTP server which the XSCF refers to
must be a server on which the stratum
value is smaller than 5. When you
changed the NTP server to refer to,
reboot the XSCF.
When the stratum value has been set
correctly and the time can't be
synchronized, use the showntp(8)
command to check the jitter value to
be displayed.
If this value is large, please reboot the
XSCF.
Execute the domain reset one more
time, or power off the domain and
then power on again.
Wait for the CLI to complete. The rest
of the system will function normally
during this time.
• The CLI can also be aborted by ^C.
Note that the operation (disabling
e-mail report) is completed, even if
^C is used.
• showemailreport can be used to
confirm that the e-mail service has
been disabled.
Chapter 3 Information About Software 29